1984 Jeep CJ7 in Spencerport, New York

1984 Jeep CJ7
Price: $12,000
Type: Cars, For Sale

frame completely gone over and any factory holes welded up and sleeved (so no dirt or water can get inside) and has 6 point mounts attached and painted with POR front and rear bumpers made and welded on all 1/4" thick. front bumpers has 2 tow hooks, rear has 2 D rings. custom rock rails on both sides also make of 1/4"
4inch leaf spring lift 2 inch solid aluminum body lift. rear teraflex shackles
Fiberglass body, hood, and grill. Steel flat fenders, windshield frame, rear corner gaurds (3/16" thick) and half doors
six point roll cage, and seat belt frame
9000 I warn winch, 36X13.50-15lts Irocks on rock crusher rims (some minor off roading cuts, no leaks, but very little wear (95%))
1990 302 ho fuel injected motor has roller rockers and forged pistons, t176 trans , and a Dana 300 with tera low kit (4 to 1)
front and rear Dana 44 axles from a scout II 4:10 gears, rear has a lock right and the front has a modified Lincoln locker in it all vents are mounted high inside the cab. both axles have rock rings make of 1/4"
steering box has a stiffener on it, rear bumper has a tire carrier and a hi lift jack. Inside door, and dash are custom made diamond plate and so is the inside battery box with disconnect switch. has a set of Hella 500 halogen lights on the windshield. Lots of stainless( hood, fender, door, and windshield hinges, wiper motor cover, air intake grill, hood hold downs, gas tank filler, windshild hold down nuts and plate.
parts that are new are:
front wheel bearings, rear turn signals, rear drive shaft, all gauges (except rpm and Speedo) front seat covers, clutch and throw out bearing, battery, front brakes, front seatbelts, all break lines, all fuel lines, gas tank and skid plate (with side armor)
parts that have less that 100 miles on them
steering box, alternator, smog pump deletion kit, terafelx rear shackles, body mounts, front seat belts, and hella 500 lights
Jeep has had every bolt taken out and replaced with stainless or class 8 bolts. the soft top it like new. except for the upper doors, it has a flip and fold rear seat with shoulder belts and the front has 4 point harnesses. I have alot of extra parts for the jeep that will come with it including a T18 wide range that I was planning to put into it. also I have an extra rear axle shaft 2 extra front outer and a front inner short side. also have a line lock, some webbing handles, fire extinguisher, warn winch gloves, new pinion seals, new steering column bearing. and I might have some other stuff sitting around for it.
This is a very nice jeep. alot of customizing has been done. however it is not perfect. it has paint flaws (scratches, runs, etc...) it will need some stuff to be ROAD legal. ( front sway bar, parking brake (including line lock), replace rear shackle with stock, brakes need bleed, Speedo need calibration (not even close))
so if you are looking for a perfect jeep look elsewhere (expect to pay twice what I am asking for it too) I had built this as a off-road vehicle not a mall crawler. it doesn't need anything for that.
Any question just give me a email and i will respond back. 12,000 OBO

City: Spencerport  Zip code: 14559 Category: Cars
Cars in Spencerport for sale


View similar ads: Cars, Cars in Spencerport for sale
Similar ads: